
Warm brick color that stays put in the rain
Brick Paver Sealing in Westchase, FL
Call (656) 254-4152 for a free estimate to seal the brick pavers at your Westchase home.
- Brings out deeper paver color
- Fresh joint sand helps lock pavers in place
- Gives weeds less room to grow
- Makes the surface easier to keep clean
- Free estimate, no obligation
Request a Free Estimate
Free, no obligation.
Can a Westchase contractor seal brick pavers, and when does a reply come?
Yes, brick paver sealing is offered across Westchase, and a contractor answers each request within 1 business day, typically much sooner. There is no charge for the estimate and no pressure to hire. To check a date, call (656) 254-4152.
Brick in a Westchase yard takes sealer differently from the concrete pavers most guides describe. It drinks in more product, it dries slowly in shade and it can darken more than you expect. Done well, sealing keeps the warm tones from fading and the joints from emptying in summer storms. Mention the age and color of your brick when you request a free estimate.
Which Westchase villages and nearby places have brick paver sealing?
A contractor covers brick drives, courtyards and lanai floors in Westchase and in each place below. Every place has a page of its own. If yours is not named, call (656) 254-4152.

Why does brick need a different sealer plan than concrete pavers?
Brick is more absorbent. Unilock says brick pavers soak up more sealer than concrete and often suit a matte or low gloss finish that keeps their natural look. Rusty's Pro Wash and Seal says brick can take sealers differently and often needs products made for clay. Concrete wants a breathable coat, per Unilock, but clay wants one chosen for clay. To have the right product named for your brick, call (656) 254-4152.
Washing changes too. Rusty's says concrete can take higher pressure than brick or pavers, and that joints need care to avoid losing sand. Unilock warns that the wrong nozzle or pressure can crack pavers and blow out sand. Ask what pressure and tool the contractor plans to use when you request a free estimate.
Where do brick pavers show up around Westchase, and why does that matter?
Mark's Painting says many Westchase homes have brick paver driveways, courtyards and lanai extensions that match the community's coordinated look. Westchase itself was planned: Wikipedia says West Park Village took its styling from Hyde Park, and Rusty's describes Hyde Park as a place of brick-lined streets. A mismatched finish on one Westchase drive shows next to the neighbors. When you request a free estimate, mention whether the street has a shared look to match.
What does the brick paver sealing process involve at a Westchase home?
The Westchase process is built around three questions: what coat the brick already carries, how dry is it and how much will it take up. Answer those first and the coat goes on evenly. To go through the order of work for your brick, call (656) 254-4152.
1. Identify the old coat
Unilock says to test old and new sealers for compatibility. A resurfacing guide notes that an unknown old finish can give uneven color. Failed or hazed sealer is stripped to bare brick.
2. Wash with a lighter hand
Rusty's uses a rotary surface cleaner so water spreads evenly, and keeps pressure down on brick and joints.
3. Treat efflorescence and stains
Unilock says white salt deposits must be gone before a coat. Rust and oil are treated, as sealing over them locks them in.
4. Let it dry through
A few hours in warm sun, about 24 hours in shade, and longer after rain, according to Unilock.
5. Test, then seal
A hidden section is sealed and left to cure so the color change is known. Mark's Painting does that and shows sample boards. The full coat follows.
Matte, satin or wet look: which finish suits Westchase brick?
Choose by color and footing. Rusty's lists finishes from natural, with no sheen, through satin to the wet look, with wet look the most popular beside pools. Unilock says brick often wants matte or low gloss. A wet look deepens color, which can turn a warm red toward brown. Mark's Painting says wet look reads darker and richer on tan and charcoal blends, and matte reads flatter and closer to stucco. Since Westchase deed restrictions mostly speak about color, ask the contractor to cure a test patch first. Questions on finishes go to (656) 254-4152.
What does brick paver sealing cost in Westchase?
Westchase brick has no published price of its own, so the figures below come from the pieces Tampa Bay companies do publish. Rusty's lists $1.25 to $2.50 per square foot for the clean, sand and seal, $1.00 to $1.75 for the coat alone, and a minimum charge of $500 to $1,000. At those rates a 300 square foot brick courtyard falls under the minimum, and an 800 square foot drive lands at $1,000 to $2,000. For a price on your brick, request a free estimate.
Condition decides how far a bid strays. Rusty's says it strips failed or hazed sealer before starting, and that sealing over algae or stains traps them. A Westchase rate that leaves out stripping may become a larger bill later. Phone (656) 254-4152 to check a bid against the table.
| What is priced | Published figure | Where it comes from |
|---|---|---|
| Sealing coat only, per square foot | $1.00 to $1.75 | Rusty's paver sealing service page |
| Clean, sand and seal, per square foot | $1.25 to $2.50 | Rusty's cost guide for Tampa Bay |
| 300 sq ft courtyard, clean, sand and seal | $375 to $750, or the minimum charge | The same range multiplied out |
| 800 sq ft brick drive, clean, sand and seal | $1,000 to $2,000 | The same range multiplied out |
| Small job minimum | $500 to $1,000 | The charge Rusty's says most Tampa Bay companies set |
| Failed old sealer stripped before the new coat | Priced on site | Rusty's strips it first, but publishes no separate rate |
No company page opened for this guide prints a rate for brick on its own. This table is built from the published pieces for pavers in general: the coat, the wash and sand, and the minimum charge. Brick that needs a clay formulated product or a strip may cost more, so the first quote matters.

How long does a coat last on brick in Westchase?
The published range is 3 to 5 years from Unilock and Rusty's, and Rusty's service page recommends 2 to 3 years. Pool Renovators puts polyurethane on brick near 3 years. Sun on an open Westchase drive wears a coat first, and a covered entry holds one longest. Mark's Painting says Westchase humidity, rain, pollen and UV, not salt spray, are what act on pavers here. To plan the next coat, call (656) 254-4152.
What goes wrong when Westchase brick is sealed in a hurry?
Three faults repeat. Moisture sealed in turns the coat white, as Unilock explains. A thick or uneven pass leaves streaks and gloss differences, and Unilock says to finish in a single session and lift excess with a dry roller. A product that clashes with the old coat peels. A contractor who waits for dry pavers, tests first and finishes the job in a single session avoids all three. Ask how that plan fits your forecast when you request a free estimate.
What do sealed brick pavers look like around Westchase?








What do Westchase homeowners ask about sealing brick pavers?
Is it better to spray or roll paver sealer?
Brick soaks up more sealer than concrete, so even application matters more. Unilock suggests an application sprayer for coverage and a dry roller to take up excess so streaks and drips do not set. Rusty's applies sealer with a pressurized pump rig and says a paint roller alone leaves a thinner coat. A contractor can explain which tool goes on which part of your brick.
How often should I seal pavers in Florida?
Unilock and Rusty's both give 3 to 5 years as the usual span for pavers, and Rusty's own service page recommends 2 to 3 years in Tampa Bay conditions. Brick is more absorbent than concrete, so a coat that is worn through lets moisture in sooner. Pool Renovators lists polyurethane on brick at about every 3 years in Florida.
Can I seal my pavers myself?
A homeowner can try, yet brick is the unforgiving case. Unilock says brick pavers soak up sealer more than concrete, so the product must be chosen with care, and it recommends an authorized contractor for people sealing for the first time. A wrong product on brick can leave blotches or haze that must be stripped, which costs more than a first quote would have.
How much does it cost to install pavers in Florida?
Laying brick pavers is a separate trade from sealing them, and no brick-only install price turned up in the pages read for this guide. The nearest figure is Reliable Hardscapes' number for a Westchase driveway, around $15,000 to tear out concrete and lay pavers. Keeping existing brick sealed is the lower-cost path, near $1.25 to $2.50 per square foot to clean, sand and seal.
Will sealer change the color of my brick pavers?
Usually a little. Mark's Painting says sealer changes paver color to some degree no matter what, typically darkening it slightly, and tests on a hidden section first. Unilock says a color enhancing sealer brings out the natural tones, while a natural finish stays closest to the original. Ask to see a cured test patch before the full job.
Does a sealer make brick pavers slippery?
A high gloss one can. Unilock lists high gloss as a slip hazard when wet and says matte sealers are the safer choice, and it adds that brick often wants a matte or low gloss finish to look natural. Rusty's says traction additives are available for wet areas such as pool decks.
Can new sealer go over an old coat on brick pavers?
Sometimes, if the two are compatible. Unilock says to test old and new sealers together before resealing, and Pool Renovators says a water-based product over a solvent-based one can fail to bond and peel. Rusty's strips failed or hazed sealer to bare pavers first. If the old coat is unknown, a test area settles it.
Why does my sealed brick look cloudy or white?
Trapped moisture, too much sealer or an old product that clashes can all cause it, Unilock says. Efflorescence, the powdery calcium salt, can also come up through new pavers, and Unilock says it should be gone before sealing. Rusty's adds that sealing over stains or algae traps them. Haze is a reason to stop and have the pavers checked.
Do brick pavers in the shade of a Westchase yard dry more slowly?
Yes. Unilock says drying time stretches in cooler shady spots, to about a day, and flags slower cure for brick in the shade. Mark's Painting says mature trees and nearby ponds keep many Westchase yards shaded and slow to dry, so sealing waits until the brick is dry through, not only on the surface.
More paver services in Westchase
Brick is rarely the only paved surface at a house. These pages cover the others, and (656) 254-4152 reaches a contractor for any of them.
Ready to keep your brick pavers looking warm?
Ring the number or use the short form, and a contractor gets back to you inside 1 business day, typically much sooner.
Free, no obligation
